Products > Test Equipment

Frequency Counter 2Ero Selection

(1/1)

ko4nrbs:
My counter works very well to monitor my old Heathkit HG-10 VFO but when powered down I have to always select 2Ero before it will start accurately displaying the frequency.  Is there any way to permanently select 2Ero so I don't have to select it every time?
Thank you,
Bill


https://usa.banggood.com/1Hz-50MHz-High-Sensitivity-Frequency-Meter-Counter-Measurement-Tester-Module-7V-9V-50mA-p-1662557.html?cur_warehouse=CN

PA0PBZ:
I have no idea what 2Ero means and it looks like I'm not the only one.

ko4nrbs:
It is one of the selections on the PCB via a push button.

It's shown on this site at the end of the page.
https://kc7zow.tripod.com/hamradio/id6.html

Bill

AVGresponding:
Presumably it means "zero" and is to reset the counter?

electr_peter:

--- Quote from: AVGresponding on December 15, 2022, 07:47:27 pm ---Presumably it means "zero" and is to reset the counter?

--- End quote ---
Yes. OP meant "Zero" option displayed on 7-segment display.

Navigation

[0] Message Index

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod