FSIQ / FSEM Rohde&Schwarz:Can not display analyzer display on external monitor

[hafrse]

Hello,

When connecting external monitor using the PC monitor output, the system boots to WIN NT correctly but when it has loaded all the components and tries to display the analyzer display in the end of the startup process, is says :
"An external Monitor has not been connected or configured..." (pleaase see picture)

I tried to choose different settings, etc... same problem, any clues what could it be wrong?

My system is running under BIOS 3.3, win NT , firmware 4.40.3

Many thanks in advance!

[Bernd]

Hello hafrse,

Press: SETUP / GENERAL SETUP / MONITOR CONECTED

Then it will work.
Regards, Bernd