Products > Test Equipment
FSP30/40 embedded windows xp for spectrum analyzer.
<< < (5/16) > >>
DavidAlfa:
So instead of trying the easy, simple way, copying the SYSTEM file from the restore point folder to system32, you reinstalled the whole thing  :-//
Did you made backup or not?

Luckly most people don't scrap the car for a flat tire.
coromonadalix:
@DavidAlfa    Dont too critical,  the OP may or may not have experiece,  but he's getting somewhere now


@g7kbr67   if you have the system folder backup  and or the iso file of your equipment and extracted the same folder

With windows devices manager on each error  you can do an automatic or manual search for the drivers, DO A MANUAL search and point  where you have stored the repertory / files

It should be able to see and install the needed files   BUT sometimes     you need all the files and subdirectories of the system folder to be at the same place / in the same folder  for all the *.cat, *.dll's, *.inf, *.sys files  etc ...

Xp can do a search for drivers   but can be stupid at times ....

In the system properties   wich version of XP do you have, is it SP1 SP2 ???    you have a package update of XP SP3  available  to download
https://www.majorgeeks.com/files/details/microsoft_windows_xp_service_pack_3.html

Install it  and reboot before going further,  it resolve a few things and upgrade some component BUT an XP SP2 windows is usually fine with equipment  IF  you do not let it go on the internet, if it has an network port on it

Since XP  is outdated and not secure in anyways for web stuff   but useful in a closed  network
g7kbr67:
Hi

I have the following on the flash drive, I have not cleared that down.  All I have done is install a SATA drive and build windows xp and that all.  I have the following on the flash drive see from screenshot.

I can copy the flash card both C and D onto a DVD for safe keeping.

Regards

Paul

g7kbr67:
Hi

Can you confirm the location of the restore folder?

Regards


Paul
g7kbr67:
Hi coromonadalix

I have installed on the SATA drive windows pro and the SP2.

In the hardware profile, the only issues I can see are the motherboard drivers for interfaces, but will this cause issues with the FSP40.

The other thing I notice people are advising is to recover the restore point system to the system 32 folder, not sure the location of the retore point.

Regards

Paul

Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod