Products > Test Equipment

FSP30/40 embedded windows xp for spectrum analyzer.

<< < (7/16) > >>

g7kbr67:
This is on my fresh install of windows xp? FSP_450_SP5_GlorisZip - 1.zip

g7kbr67:
Ok, it is installing onto the FSP40 now, FSP_450_SP5_GlorisZip - 1.zip

g7kbr67:
Do I need to run the "Extensions" folder, or not.  I wasn't sure from your post.

JeremyC:

--- Quote from: g7kbr67 on November 24, 2022, 07:32:45 am ---Hi All

My last Plea for help, I have posted a couple of emails about the issue.  The Windows could not start because the following file is missing or corrupt \WINNT\SYSTEM32\CONFIG\SYSTEM.   I took the top off and I have a Compact Flash drive with the following information on it. Part No. 1303.0417.07, Flash Disk for R&S FSP with Windows XP.

I don't have a Windows build embedded XP disk, or the analyzers build software and R&S have told me they can't help.  If only I had a friend who works in their repair\service department.

Could I just install a standard Windows XP build and install the firmware which I believe is still on the R&S website?  https://www.rohde-schwarz.com/firmware/fsp40/

I would need to know on the old drive as I can still read the drive if I put it in a caddy, where the calibration data is for it.

Otherwise, the unit is a dustbin job.

Any help would be much apricated.

Regards


Paul P

--- End quote ---

Paul, you should try to use "Virtualbox" VM (it's free). Install Windows XP in new VM, link one of your USB ports with the VM and you're set. You may create snapshots of the VM before beginning and if something would go wrong you can always roll back to the before iteration in ~1 minute.
Link to Virtualbox:  https://www.virtualbox.org/

coromonadalix:
this is my last help, i think there is some misunderstanding, language barriers  or novice level in theses kind of problems

https://www.sendspace.com/file/m51gtx

This is the system32 files of the 1.2 gig iso link of ealier threads, extract them on a usb key and make windows search manually for them

There was an "firmware" folder too included ???  maybe they are the missing drivers  ???

and one New folder with  3x installable  *.msi files,  i dont know what they are ....

good luck

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod