Products > Test Equipment
FSP30/40 embedded windows xp for spectrum analyzer.
(1/1)
g7kbr67:
Hi All
After following a previous message on the group regarding a failure of a drive in a Rohde and Schwarz FSP40.
I have a FSP40 which when boots saying, I have a missing file (Windows boot-up). I took the top off and I have a Compact Flash drive with the following information on it.
Part No. 1303.0417.07, Flash Disk for R&S FSP with Windows XP.
Can I purchase a standard compact flash drive? Is it a 32GB one?
Also Is the build the same ISO available for download on this site? From K04BB's website. http://www.ko4bb.com/getsimple/index.php?id=manuals&dir=Rohde_Schwarz/Rohde_Schwarz_FSP?
See photos below.
Regards
Paul
g7kbr67:
Update
Hi have tried using the image on this original message, I am using a USB stick as the boot device with the image on. But I get a blue screen when it boots, " A problem has been detected and windows has been shut down to prevent damage to your computer"
I have attached the jpg to the message.
Regards
Paul
coromonadalix:
how did you extract this iso ?? power iso, ultra iso have settings for boot device iso sources ...
or you could re-install from scratch if you have mobo bios access and put an bootable device like an cd-rom
recover the missing drivers afterwards ???
g7kbr67:
Hi
I used Rufus to build the USB stick, when you say install from scratch. I could use a CDROM drive and build the Embedded Windows OS. But I am not sure what version and where to get it from? I have the original Compact Flash drive which I hope has the calibration data on it ok. Can the firmware still be download from a site for the build on a fresh version of embedded XP.
Regards
Paul
Navigation
[0] Message Index
Go to full version