Products > Test Equipment

FY6900 Signal Generator USB PC interface

(1/3) > >>

pman92:
Hey guys,
I've got a FY6900 signal generator. It has a USB port which is apparently used to connect to your PC, and there is software you can use to control it, or control it over USB serial.

I've seen the software in youtube videos - "DDS signal PC software". It probably came on a disc when I bought it that I've long since lost. But I cannot find a download for it anywhere on the internet.

I did find the "Host Computer Communication Protocol Specification" PDF from Feeltech online. I tried opening Putty at both 115200 and 9600 baud and sending a few commands, but nothing worked.

My unit has the following under the system menu:
Model: FY6900H-100M
Version: V1.3.1.3

Can anyone help me out? Getting this working over serial will save me a ton of time.

Cheers

pman92:
I ended up finding the PC software (it was included with the download labelled as user guide on the feeltech website, but that wasnt really made clear).

When I open the software and connect the USB cable, I get a "Runtime error 380 - invalid property value". It lists the model (MODEL:FY6900H-100M) and COM port in the bottom RH corner. But nothing works.
 

MarcFinns:
I just bought the device and i have the same issue.
Did anyone solve it? thanks!

pu6k1n:
I just bought the device and i have the same issue.
Did anyone solve it? thanks!

Nobody4356:
I just bought the device and i have the same issue.
Did anyone solve it? thanks!

Navigation

[0] Message Index

[#] Next page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod