| Products > Test Equipment |
| GDM-8351 DMM calibration procedure |
| (1/2) > >> |
| kakci:
Hello! I'm looking for the calibration procedure on this DMM or service manual if anyone has it. |
| coromonadalix:
Question, did you ask Gw Instek ?? |
| kakci:
Yes heres the answer: "IF you find that your unit is giving false readings and it has to be adjusted/repaired, then this can only be done by GW representative." I was asking for the calibration procedure. Trying to ask here since someone succeeded with the GDM-8251 calibration procedure and posted it here. But the 8351 doesnt have an USB Type-A port. |
| PeZe:
Hello everyone, Has anyone made any progress with the calibration procedure for this multimeter? I just got it second hand and would like to do a calibration/adjustment. So far what I have been able to find is that the procedure from the older model which had a dedicated USB port for the calibration key cannot be used as it is missing on this model. I have also asked GW instek support for the procedure but the reply was clear - they will not share it unless you are an accredited laboratory or authorised distributor. :-// |
| Martin72:
Hi, --- Quote ---I just got it second hand and would like to do a calibration/adjustment. --- End quote --- Is that necessary, how did you find out? Do you have the appropriate means for such a calibration? If not, I would have the meter calibrated externally if I were you. |
| Navigation |
| Message Index |
| Next page |