Products > Test Equipment
GDM-8351 DMM calibration procedure
kakci:
Hello!
I'm looking for the calibration procedure on this DMM or service manual if anyone has it.
coromonadalix:
Question, did you ask Gw Instek ??
kakci:
Yes heres the answer:
"IF you find that your unit is giving false readings and it has to be adjusted/repaired, then this can only be done by GW representative."
I was asking for the calibration procedure.
Trying to ask here since someone succeeded with the GDM-8251 calibration procedure and posted it here. But the 8351 doesnt have an USB Type-A port.
PeZe:
Hello everyone,
Has anyone made any progress with the calibration procedure for this multimeter?
I just got it second hand and would like to do a calibration/adjustment.
So far what I have been able to find is that the procedure from the older model which had a dedicated USB port for the calibration key cannot be used as it is missing on this model.
I have also asked GW instek support for the procedure but the reply was clear - they will not share it unless you are an accredited laboratory or authorised distributor. :-//
Martin72:
Hi,
--- Quote ---I just got it second hand and would like to do a calibration/adjustment.
--- End quote ---
Is that necessary, how did you find out?
Do you have the appropriate means for such a calibration?
If not, I would have the meter calibrated externally if I were you.
Navigation
[0] Message Index
[#] Next page
Go to full version