Products > Test Equipment

Gould Ultima / Nicolet Accura DSO software needed.

<< < (3/8) > >>

Kowilli:
I have created image from the hard drive with "Drive Snapeshot".
link to Google drive: https://drive.google.com/drive/folders/144wFaoal75S2RpnGDz6rabrkihhACc4D?usp=sharing

i will share the files during the day.

Procedure:
- Connect IDE harddisk >20GB to IDE port of any PC
- Start Snapshot -> "Restore Disk from File
- Follow instructions (source, destination, ect.)

Kowilli:
Here are a few more pictures and tips:

Kowilli:
I have the possibility to get a user manual, if interested you can contribute to the costs.  The provider requires 75Eur.  It's a little too expensive for me.  The operation of the device is not easy although I am an electrical engineer and have experience.

shakalnokturn:
Thanks Kowilli for going to the trouble of imaging the HDD, I don't know yet whether I'll be able to make use of it of if I'll need the user manual but if your image allows me to get the DSO running again I'll be pleased to help you in buying the documentation.

shakalnokturn:
Thanks to Kowilli I have a HDD image to work from.

When I bought this scope I was told that the internal LCD had stopped working and that it had been used with an external monitor until the HDD failed.


Points noticed recently:

One cracked hybrid resistor network on CH2, I assume it's for attenuation.

PCI interface board to acquisition system also containing internal LCD graphics and an additional VGA output (+GPIB?) has had the FPGA's and ASIC's reworked.

Power connector to acquisition board had previously heated at the white wires, burnt contacts had been corrected by soldering straight to the power header.

Bad contacts related to the ATI Mach64 VT4 regular VGA output. (Not sure how the 2 VGA outputs are handled, I assume one can mirror the scope screen while the other can be used for the PC.


After copying the HDD image to a spare 40GB drive I'm greeted with a German Win 2k boot screen followed by a blue screen failure that seems to indicate that the OS is missing the IDE drivers.
Going by the photos Kowilli posted we have different mainboard models mine is a Tyan S1854.

Next step is getting hold Win 2k pro setup files to see if I can get away with just a system refresh and change of language. (My German is poor...)

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod