Products > Test Equipment

> 1 GHz DIY differential probes

<< < (27/35) > >>

nctnico:

--- Quote from: paul67 on March 14, 2019, 10:29:26 pm ---Thanks for the delivery of the probe, Nico. It works really nicely! I'm very happy with it. I wondered, what do you do with the LMH3401 inverting output... connect directly to 0V, or...?
I looked at the datasheet but couldn't see guidance for using in single-ended output mode.

--- End quote ---
The inverted output is terminated to ground with a (in total) 50 Ohm resistor so both output see (about) the same load.

Evodad:
Hi ntcnico,

Any chance you have any probes left ?
This was an interesting thread. Why did it not survive longer ? Any spin-offs ?

// Per

nctnico:

--- Quote from: Evodad on November 01, 2019, 06:04:13 pm ---Hi ntcnico,

Any chance you have any probes left ?
This was an interesting thread. Why did it not survive longer ? Any spin-offs ?

// Per

--- End quote ---
Actually I have 20 new probes fresh from the assembler.

Evodad:
That was good news  :)

Any modifications since the last batch ?

May I buy 2 of you ?

)) Per

teomondo:
Dear ntcnico
Is DIP1400 1.4GHz differential probe currently avaliable?
I have an Operating manual dated 2019 any new version avaliable?
What about the price of DIP1400 1.4GHz differential probe and how I can buy it.
Thanks for your answer
Roberto

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod