Products > Test Equipment
Gw Instek GDS2204E (200MHz 4 channel DSO) review
<< < (32/44) > >>
rhb:
How did you collect the data for the plot?
seronday:
Using the DSO voltage measurement function to measure the displayed signal level from a calibrated RF signal generator at various frequencies.
The reference is the level measured at 1Mhz.
CC555:
I can't update the oscilloscope to v1.35: https://www.gwinstek.com/en-global/products/detail/GDS-2000E

it seems the .upg file is not valid for my oscilloscope (gds-2000e)  |O, upgrading by safe mode.
wraper:

--- Quote from: CC555 on August 22, 2018, 09:01:13 pm ---I can't update the oscilloscope to v1.35: https://www.gwinstek.com/en-global/products/detail/GDS-2000E

it seems the .upg file is not valid for my oscilloscope (gds-2000e)  |O, upgrading by safe mode.

--- End quote ---
Are you sure you did not download wrong or corrupted file? Sounds like you want to brick your scope.
CC555:
Thx for the reply,

I think the .upg file is good, I downloaded it several times.

Did anyone update the oscilloscope to v1.35?

Current version in my oscilloscope v1.34.

Thanks
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod