Products > Test Equipment

Gw Instek GDS2204E (200MHz 4 channel DSO) review

<< < (32/44) > >>

rhb:
How did you collect the data for the plot?

seronday:
Using the DSO voltage measurement function to measure the displayed signal level from a calibrated RF signal generator at various frequencies.
The reference is the level measured at 1Mhz.

CC555:
I can't update the oscilloscope to v1.35: https://www.gwinstek.com/en-global/products/detail/GDS-2000E

it seems the .upg file is not valid for my oscilloscope (gds-2000e)  |O, upgrading by safe mode.

wraper:

--- Quote from: CC555 on August 22, 2018, 09:01:13 pm ---I can't update the oscilloscope to v1.35: https://www.gwinstek.com/en-global/products/detail/GDS-2000E

it seems the .upg file is not valid for my oscilloscope (gds-2000e)  |O, upgrading by safe mode.

--- End quote ---
Are you sure you did not download wrong or corrupted file? Sounds like you want to brick your scope.

CC555:
Thx for the reply,

I think the .upg file is good, I downloaded it several times.

Did anyone update the oscilloscope to v1.35?

Current version in my oscilloscope v1.34.

Thanks

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod