Products > Test Equipment
Gw Instek GDS2204E (200MHz 4 channel DSO) review
Asymmetric13:
@nctnico @saturation May I propose splitting the discussion on the new MSO series into a new thread
https://www.eevblog.com/forum/testgear/gw-instek-announces-new-mso-2000/
and keep this thread focussed on the "original" GDS-2000E (unless specific comparisons arise).
Thank you
wer:
Does anyone actively use the remote mount feature? I used it for a few weeks, and it was nice to offload images instantly. It no longer works, and doesn't attempt to connect. I'm unable to erase the settings, or get any further debug. I reached out to support months ago, but they didn't offer a solution. Just curious if anyone else has seen this problem.
My other ask from support (besides a way to wipe it clean), was for login info. Has anyone gotten that yet? I tried swapping out hash's but something about ubifs must validate the bits changed and reject the patched firmware. I didn't try too hard and don't know much about ubi.
My ongoing disk mount Error is "Mount remote disk fail.", it's persisted through all firmware updates and resets and attempts to factory default, app removal re-installs. It kills me that I can't just log in and fix it. Especially when there is a damn ssh port listening on it's network interface.
Otherwise I'm pretty happy.
Thanks for all the info in this thread. Hope it's cool I posted this here.
-=wer
nctnico:
Did you check the file server logs? Maybe something changed on the system you are trying to connect to. Also try another network cable (even if the cable you use now seems to work) because many network problems are caused by cables.
wer:
It's working again.
Thanks for the thought. I had run tcpdumps and all kinds of things previously, and indeed it's all my fault. caught it trying, and fixed it.
-=wer
dfnr2:
Am I overlooking something, or is there no user-definable baud rate for the UART serial decode?
I have access to a 2204E, and was trying it out on a system with a UART stream generated in programmable logic with nonstandard bit rate, and was only able to select standard baud rates.
This comes up every once in a while, and it's an oversight not to include user definable/adjustable bit rates for serial decodes in general. This seems like either an oversight in the decode module or in the UI (making it hard to find.)
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version