| Products > Test Equipment |
| Hacking the Siglent 2k+ Cooling System and Mount |
| << < (4/9) > >> |
| Martin72:
--- Quote from: balnazzar on November 03, 2022, 11:31:11 pm ---The sticks that actually hold the monitor are just kind of some screws bolts, say M5 (picture below). One could just buy longer M5 bolts! But then there is the problem with the torque: longer bolts, more torque. --- End quote --- I guess it´s M6 and I´ve ordered 120mm long screws, should arrive tomorrow.. Just for testing, it wasn´t a final solution because of the airflow. |
| balnazzar:
--- Quote from: Martin72 on November 04, 2022, 09:45:54 pm --- --- Quote from: balnazzar on November 03, 2022, 11:31:11 pm ---The sticks that actually hold the monitor are just kind of some screws bolts, say M5 (picture below). One could just buy longer M5 bolts! But then there is the problem with the torque: longer bolts, more torque. --- End quote --- I guess it´s M6 and I´ve ordered 120mm long screws, should arrive tomorrow.. Just for testing, it wasn´t a final solution because of the airflow. --- End quote --- It's very interesting... I think the airflow will not be impeded (if the vesa segments obstruct the fan exhaust, just use a rubber spacer, 1 cm will be sufficient...). I'm more concernet about how firmly the locking will actually be. I'll stay tuned with you ;) |
| Martin72:
--- Quote --- I´ve ordered 120mm long screws, should arrive tomorrow.. --- End quote --- Too short, 140mm would be better or much better is to forget this thing because see pic 2. But I have another idea and the purchase of the non-vesa adaptor was not useless... 8) |
| balnazzar:
--- Quote from: Martin72 on November 05, 2022, 04:53:15 pm --- --- Quote --- I´ve ordered 120mm long screws, should arrive tomorrow.. --- End quote --- Too short, 140mm would be better or much better is to forget this thing because see pic 2. But I have another idea and the purchase of the non-vesa adaptor was not useless... 8) --- End quote --- I think you can do it with 140mm crews, and rotating the holder a bit will solve the problem with thecovered button. OTOH, with screws so long, I'm not sure the whole contraption can manage the torque applied upon it.. Please tell me about the other idea, curiosity is eating me alive. :) :popcorn: Also, see this (but it wouldn't work for the 2000X+ because it has a skewed edge..): https://www.amazon.it/Adattatore-supporti-montaggio-professionale-Office-VESAPLUS/dp/B078NBQFQ9/ref=sr_1_13?__mk_it_IT=%C3%85M%C3%85%C5%BD%C3%95%C3%91&crid=2EY5JV5KMSHR1&keywords=non%2Bvesa%2Badapter&qid=1667678792&qu=eyJxc2MiOiIzLjM1IiwicXNhIjoiMi43NCIsInFzcCI6IjEuNzIifQ%3D%3D&sprefix=non%2Bvesa%2Badapte%2Caps%2C96&sr=8-13&th=1 |
| Martin72:
Actually I´m designing a backplate for the HD scope, then for the X+... Will post the finished drawings here then. Martin |
| Navigation |
| Message Index |
| Next page |
| Previous page |