Products > Test Equipment
Hacking the Siglent SDM3055 Bench DMM
<< < (23/35) > >>
Pinkus:
 :wtf: We all wish you a speedy recovery. Take care of yourself and get well!
tv84:

--- Quote from: alexvg on July 15, 2020, 04:20:47 pm ---Hello,
Just a little message to thank you for your support.
I have been sick with Covid-19 since June. Despite all the precautions taken (mask, distance, hand washing ...), that was not enough.
It's very difficult everyday with a lot of symptoms. The healthcare team is great but clueless.
Please protect each other, take care of yourself.

--- End quote ---

I wish you well!
ZhuraYuk:

--- Quote from: alexvg on July 15, 2020, 04:20:47 pm ---Hello,
Just a little message to thank you for your support.
I have been sick with Covid-19 since June. Despite all the precautions taken (mask, distance, hand washing ...), that was not enough.
It's very difficult everyday with a lot of symptoms. The healthcare team is great but clueless.
Please protect each other, take care of yourself.

--- End quote ---
I wish you a strong health and good luck.
I want to thank you for this awesome work. 3055 is very capable device. Running 6-1/2 digit mod, I checked 4 wire resistance against 10OOhm 0,002% resistance standard. Only last digit was noisy same as my freshly calibrated Keithley 2100.  Also I compensated wire resistance because it was a little 0,0136 Ohm off when 4 wires shorted. After connecting to reference resistor the reading was stable up to last digit. All measurements were dine after 2 hours warm up.
uski:

--- Quote from: alexvg on July 15, 2020, 04:20:47 pm ---I have been sick with Covid-19 since June. Despite all the precautions taken (mask, distance, hand washing ...), that was not enough.
It's very difficult everyday with a lot of symptoms. The healthcare team is great but clueless.
Please protect each other, take care of yourself.

--- End quote ---

Anyone has news of Alexia ? I just found this thread and the last message is months old, so I am worried now !
alexvg:
Hi,

I was hospitalized because of covid, a "long covid".
I went back to work a few weeks ago, it's really difficult.
I hang on, it's difficult. Little by little I know it will get better, but it takes time, lot of time.
I recently received a Keysight 34470A (the new black version).
I hope to be able to resume development quickly and provide at least a "voltmeter" version to test the capabilities.

Take care of yourself and your loved ones.
Alexia Gossa.
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod