Hello everyone.
I have both bad news and good news, in that order.
For several months I have been absent from the forum and from my project for a new firmware for the SDM3055.
I have been facing serious health problems for several months (
https://twitter.com/AlexiaGossa/status/1680524683999944705 and
https://twitter.com/AlexiaGossa/status/1714078292603490674).
But the good news are here! My health is gradually improving, but it takes time. Patience is required.
Little by little I will be able to resume my work on the SDM3055.
Another good news, Mouser has informed me that my pending components are finally available.
Over the past few months, I've been jotting down ideas in a notebook for my work on the SDM3055 so as I don't forget anything.
The work on the SDM3055 has opened up another path for me, a medical one : EEG and ECG.
I have received questions about the SDM3045 and SDM3065 asking me if my firmware can work on these models. Theoretically yes for the SDM3045, but I can't test anything, I don't have this model. For the SDM3065 this is currently not possible, there are too many internal differences.
Obviously if I had permanent access to these 2 models I could adapt my firmware there, but each thing in its time.
First health then the SDM3055.
I'm doing my best, but you have to be patient.
Sincerely, I thank you for your support.