| Products > Test Equipment |
| Half width test racking options? |
| << < (3/3) |
| beanflying:
1/2 width Rack bits especially importing them into Oz will send you broke. Last time I needed a joiner and ears I rolled my own using stock Bunnings sourced Ali. The harder part was getting the screws for the 34970's in this case. Fairly easy to insert a plate with a single bend for one half if you only have a single bit of gear. |
| Roehrenonkel:
Hi loki42, --- Quote from: loki42 on July 22, 2023, 10:41:20 pm ---The measurement switch is full width so I haven't. --- End quote --- ...oups, i overread that. Is the setup remote-controlled, or is there manual interaction? Maybe mout the HP 3498(0) upright? Just some crazy idea.... |
| loki42:
Update, the Ikea lack rack turned out to work well. HP 34980 mounted at bottom with DM6500 and power supply above it and an oscilloscope on the next shelf. Signal gen, spare power supply and spectrum analyser currently on the shelves above but order unfixed at the moment. There's rack kits for the R&S scope but I'm thinking I might just clamp it down somehow. I've got a rack mounted switch on the back screwed in so all the stuff in the "rack" has easy connections. Test fixtures currently go next to the rack. |
| KungFuJosh:
Pics! You can use Velcro "One Wrap" to mount it all down. |
| loki42:
First two shelf of lack rack. Network switch at back. |
| Navigation |
| Message Index |
| Previous page |