Products > Test Equipment
Half width test racking options?
(1/3) > >>
loki42:
So my post pcb assembly QA tower of test needs some tidying.  Currently it's a 19" width agilent switch measure with a half width keithley, power supply and oscilloscope stacked on those.  Is there a better way to stack these?  Ikea lack?  A fancier solution?  Is there something for mounting half width keithley gear in a 19" rack? 
Roehrenonkel:
Hi loki42,

have you considered a 9.5"-Rack? (Same Rails and Nuts but half the width).

Good luck
loki42:
The measurement switch is full width so I haven't.
CatalinaWOW:
There are lots of mounts for half rack equipment which already have rack mounting ears.  One example:

https://www.redco.com/Rackmout-Kit-For-Half-Rack-Size-units.html

It is often harder to find the rack mounting adaptors for the equipment itself.  Vendors often charge platinum prices for the kits.  But I would look seriously at 3D printing appropriate stuff for todays lightweight equipment.
SL4P:
scratch around the bulk auctions, you may find some Tektronix half-rach chassis you can use.
Used with video test equipment - analog waveform and vector monitors come to mind.
Navigation
Message Index
Next page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod