Products > Test Equipment
Half width test racking options?
loki42:
So my post pcb assembly QA tower of test needs some tidying. Currently it's a 19" width agilent switch measure with a half width keithley, power supply and oscilloscope stacked on those. Is there a better way to stack these? Ikea lack? A fancier solution? Is there something for mounting half width keithley gear in a 19" rack?
Roehrenonkel:
Hi loki42,
have you considered a 9.5"-Rack? (Same Rails and Nuts but half the width).
Good luck
loki42:
The measurement switch is full width so I haven't.
CatalinaWOW:
There are lots of mounts for half rack equipment which already have rack mounting ears. One example:
https://www.redco.com/Rackmout-Kit-For-Half-Rack-Size-units.html
It is often harder to find the rack mounting adaptors for the equipment itself. Vendors often charge platinum prices for the kits. But I would look seriously at 3D printing appropriate stuff for todays lightweight equipment.
SL4P:
scratch around the bulk auctions, you may find some Tektronix half-rach chassis you can use.
Used with video test equipment - analog waveform and vector monitors come to mind.
Navigation
[0] Message Index
[#] Next page
Go to full version