Products > Test Equipment
Hantek 2000 series - 2C42/2C72/2D42/2D72
<< < (28/50) > >>
Gorkde:
But this is 15% also as I said calibration did nothing.

What about connecting a probe at calibration? Maybe this changes it?

The scope line does show the same offset. As well as the cursor measurements
gongye5776601:
Hello, I have a HANTEK 2D72 turned off now.Now you can't get into DFU mode anyway. I want to ask if you have any HEX files read by stlink. I want to revive my machine. Thank you!
Andbro:
Hi,

Does the oscilloscope part Hantek is better than Jinhan and the FNRSI 5012-H ?

Thank
Dainis:
Carefully reading the forum, I couldn't find a 100% answer, is the hardware of 2X42 and 2X72 series identical or different?
Microcheap:

--- Quote from: Andbro on September 01, 2019, 05:38:23 pm ---Does the oscilloscope part Hantek is better than Jinhan and the FNRSI 5012-H ?

--- End quote ---

I don't know about the Jinhan, but I have a 2D42 and I just got one of these 5012h with the only intention to compare it to the Hantek. I didn't have time to play with it yet though but, my first impression is good. If you only need the scope and 1 channel is enough for you, I think the 5012 can be considered.

I will try to do a comparative later and post more details here.


--- Quote from: Dainis on September 04, 2019, 12:02:12 pm ---Carefully reading the forum, I couldn't find a 100% answer, is the hardware of 2X42 and 2X72 series identical or different?

--- End quote ---
As far as I can tell they are identical. The only difference is that the "C" models don't have the components for the function generator soldered on the PCB.
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod