Products > Test Equipment

Hantek 2000 series - 2C42/2C72/2D42/2D72

<< < (28/50) > >>

Gorkde:
But this is 15% also as I said calibration did nothing.

What about connecting a probe at calibration? Maybe this changes it?

The scope line does show the same offset. As well as the cursor measurements

gongye5776601:
Hello, I have a HANTEK 2D72 turned off now.Now you can't get into DFU mode anyway. I want to ask if you have any HEX files read by stlink. I want to revive my machine. Thank you!

Andbro:
Hi,

Does the oscilloscope part Hantek is better than Jinhan and the FNRSI 5012-H ?

Thank

Dainis:
Carefully reading the forum, I couldn't find a 100% answer, is the hardware of 2X42 and 2X72 series identical or different?

Microcheap:

--- Quote from: Andbro on September 01, 2019, 05:38:23 pm ---Does the oscilloscope part Hantek is better than Jinhan and the FNRSI 5012-H ?

--- End quote ---

I don't know about the Jinhan, but I have a 2D42 and I just got one of these 5012h with the only intention to compare it to the Hantek. I didn't have time to play with it yet though but, my first impression is good. If you only need the scope and 1 channel is enough for you, I think the 5012 can be considered.

I will try to do a comparative later and post more details here.


--- Quote from: Dainis on September 04, 2019, 12:02:12 pm ---Carefully reading the forum, I couldn't find a 100% answer, is the hardware of 2X42 and 2X72 series identical or different?

--- End quote ---
As far as I can tell they are identical. The only difference is that the "C" models don't have the components for the function generator soldered on the PCB.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod