Products > Test Equipment

Hantek 2000 series - 2C42/2C72/2D42/2D72

<< < (37/50) > >>

Rien:
Hi I have a Hantec 2c42 but now after update it is changed in an 2D82 I like to go back to my original 2C42, but how? When i try to update again the meter is seen as an 2D82 an FPGA V255

Microcheap:
Try using the options "Force update ARM" or "Force update FPGA" or simply manually install the correct FW using DfuSe:

https://www.eediscuss.com/forum.php?mod=viewthread&tid=13676&fromuid=26055


By the way, did you managed to fix the multimeter?

Rien:
Thanks I try that. The meter is working as before yes , see my answer above.
I have take a look at it, first try was no succes, but after that I have downloaded both files and then force update with local files. That was the solution.
Everything is now ok also the resistance measurement.

Pinkus:
Caution, my Kaspersky shows a Trojan-warning when I tried to enter the eediscuss-site.
Though it might be a false alarm, but I would not bet on it.

Microcheap:

--- Quote from: Pinkus on January 29, 2020, 07:42:04 am ---Caution, my Kaspersky shows a Trojan-warning when I tried to enter the eediscuss-site.
Though it might be a false alarm, but I would not bet on it.

--- End quote ---

Probably a false alarm, I never had a problem there. I also checked it with Virustotal.com and it came clean:

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod