| Products > Test Equipment |
| Hantek 2000 series - 2C42/2C72/2D42/2D72 |
| << < (38/50) > >> |
| Microcheap:
--- Quote from: Rien on January 22, 2020, 08:40:04 am ---Have done , but the result is not good 47r r is read 51r 330r = 360r 460r = 5,10K 510r = 5.6K 2k2 = 21 k 3k3 = 3.6k 4k7 = 4.6k 5k = 5k 50k =50k 200k =280k So i can forget the measuring of Resistance with this meter. but my own fault. --- End quote --- There are 2 potentiometers close to the batteries' holder on the PCB, those are used to calibrate the meter. I just tried that once and if I recall, one adjust the AC modes and the other DC (voltage, current and resistance are adjusted at the same time). The pots are very sensitive and I strongly recommend not to play with then if you don't have another good meter to use as reference, the chances are that you will make things worse. |
| Rien:
Thanks for the info, can you tell wich poti is for what? My meter is working now good. I have tested the X-Y scope measurement and that is also workung nice. I think it is fot the hobby al good meter for a nice price. |
| Microcheap:
I like it too, it has its limitations but many times I prefer it over my ds1054z to quickly inspect a signal on a board or make a simple measurement. Regarding the pots, I know one was for AC mode and the other to DC, but I really don't remember which one is which I should have take note when I had the chance. |
| amham:
There are multiple sellers on Amazon, anyone know who is selling the latest versions for the 2D72? |
| Rien:
Hi, I like to know is it possible to make an 2C72 from an 2C42 with the ST-Link utility I have seen at github.com/circuit-specialists/Hantek-2D72 the bin file and other things. Is it still possible after flashing this bin file in the Hantek, to download updates for the instrument. I guess thet the meter must be on when the ST-Link V2 is connected to the meter?? Thanks for your reaction. Rien The Netherlands |
| Navigation |
| Message Index |
| Next page |
| Previous page |