Products > Test Equipment

Hantek 6022BE 20MHz USB DSO

<< < (210/241) > >>

daybyter:
Since I use 99% linux, I'm no win expert by any means, but did you start the app from the commandline, so you can see any error messages?

thielj:
The output in my post above was from the console - and there was nothing on the debug output. The app isn't even crashing, just terminating.

Kulturnilpferd:
Hey there,
have a 6022BE, too and want to measure some things with opamps. So I need negative voltages. If I want to measure a created 0V source I could maybe get in trouble if the Ground is connected over my USB on my Computer. To get rid of this problem I want to cut off the ground wire in the usb cable. I know if I measure above the 6022BE specs some current can get over the data lines but is the ground problem solved by this solution? Want to do a student project and doesn't have 200 bucks to spend on an hi-speed isolator  :-[
If this doesn't seem to work I had an eye on this USB3.0 fiber optic adapter but not shure how to cut the power lines in the cable or open the case without broke things  :-//



--- Quote from: daybyter on February 22, 2018, 06:00:01 pm ---Since I use 99% linux, I'm no win expert by any means, but did you start the app from the commandline, so you can see any error messages?

--- End quote ---

I have the same problem with OpenHantek on Windows and dumped two days to get it run. Its definetly a driver issue because sometime it crashed when it want to init and load the firmware on the device. Beside that their driver doesn't install right get every time an error even if i disable signed drivers. Was very angry about the bad instructions on their page for mac and windows installation. Told them on github to release a compiled dist for windows and mac but they delete the post from the github repo. Nice people there... ^^
To get rid of this shitty fuck just use the only system where it seems to run: Linux.
I have installed Ubuntu 16.04 but upgraded to 17.10 and it work's on both versions great without any issues. Just follow the instructions for Linux and it will work :)
If you don't like the design you can make it look like Windows 10: install "cinnamon" as desktop and install the "Windows 10 light" theme from b00merang.weebly.com

thielj:
Kulturnilpferd: Your post is still on Github. The maintainer closed your issue. Maybe try to be less of a 'shitty fuck' next time.

Kulturnilpferd:
Yeah, sorry I was a bit angry about myself that I couldn't get it to run on Windows  |O
I don't like that compiling thing, there is so much that can go wrong even on linux...
If you don't have much linux skills its very difficult, trust me ^^

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod