Products > Test Equipment

Hantek 6022BE 20MHz USB DSO

<< < (213/241) > >>

electrosci:
wow! thank you very much :-+

electrosci:
excuseme but again i'm not able to start the software.
i click on the exe but shoe me a black cmd windows and after 2 - 3 seconds disappears
is there step by step procedure ?

ViktorEEV:

--- Quote from: RichardK on January 31, 2016, 03:30:22 am ---Hello everyone, been a while since I have poked in here... I have some free time coming up and I want to hammer away some more Bugs, GUI and Measure in particular...
[...]
I fixed that today and when I get some more bugs fixed I'll compile a new build for everyone with updated source.

--- End quote ---

Hello, do you have an update about the current status of your program?
The current version PR19 is very promising and i would like to see a continuation of this project (if possible).

@electrosci
Did you install the attached driver?

electrosci:
yes i installed the driver.
if would be possible i need a step by step procedure for installing and run openhantek software

waste:
I managed to read all the pages of the thread, it was like a history of how the current software options came to be  , very informative and thanks to all the people who decoded the quirckness of this device

my current limitation is the 5V limit which translates to 50V with a 1:10 probe. Anything above that is reported as 5V/50V . The way I got it, is that's a firmware/software limit not a hardware one.

I tries both the original Software and OpenHantek and both seem to follow the clipping at 50V. I will try the other alternative software now , but I wanted to ask if there is a workaround that I haven't managed to decode through all these pages :)

cheers and thanks again

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod