Products > Test Equipment

Hantek 6022BE 20MHz USB DSO

<< < (228/241) > >>

sba:
Hi Martin,
That's good point about gnd wire. Thanks.
I have another question. When we short cap with ssr, signal goes through that 1K resistor, connected in series with ssr. Will it affect measurement?

Regarding BL - yes, I know if I will need analyzer, I'll have to use different software and restart scope so it will get different firmware. Mostly, I need scope for 99% of time and analyzer is just additional nice feature for almost same money on ali :)

Thank You

horo:

--- Quote from: sba on May 03, 2020, 04:19:35 pm ---When we short cap with ssr, signal goes through that 1K resistor, connected in series with ssr. Will it affect measurement?

--- End quote ---

Yes, the value changes by 0.001, but if you short the capacitor (which can be charged with a high voltage when measuring with a 10x probe) without this resistor, the ssr can be destroyed by the unlimited short circuit current.

Martin

softfoot:

I just tried running "OpenHantek-Win-x64-Release-b337" and after using Zadig it found the 6022BE but displayed the following wit no trace.

Any idea what the prioblem may be ??

Best regards,
Dave


Cliff Matthews:
If it's the BL version, push the button so it's in.

softfoot:
It's the BE.
Dave

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod