Products > Test Equipment
Hantek CC-65 AC/DC Current Probe Teardown and Testing
<< < (5/33) > >>
KlausF:
That is what I am interested in, in those variable resistors. What is adjusted with them ?
electro-56:
I was unable to get the full calibration procedure out of Hantek, but when pressed they offered this:
VR1 adjusts the scaling of the 1mV/10mA range (they called it the 100mA range), and VR2 adjusts the scaling of the 1mV/100mA range (which they called the 10A range). They also suggested squeezing the clamp jaws together while pressing the "zero" button to improve the accuracy.
howie
harrimansat:
What type of hall sensors are used? It seems a magnetoresistive bridge type no?
Mechatrommer:

--- Quote from: harrimansat on December 03, 2018, 09:12:36 pm ---What type of hall sensors are used? It seems a magnetoresistive bridge type no?

--- End quote ---
its in the OP picture, not sure what, it has SE marking on it...

harrimansat:
The other HP clamp that I have is colsed loop with inductor and hall. I don´t know how this clamp works. There´s more hall sensors in PCB?

Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod