| Products > Test Equipment |
| Hantek DSO1152S - Wont boot after firmware update |
| << < (22/26) > >> |
| aerra:
DC and AC Backup sent to PM. Maybe let's go to topic "Hantek - Tekway - DSO hack - get 200MHz bw for free" ? |
| tinhead:
as i don't have isolated model, i can't answer. But maybe the other ppl here with "S" models can check it. |
| commongrounder:
@aerra I set up my DSO1122S exactly the same way as your screen images (except I can't tell which averaging setting you were using, I chose 64). I set the probe compensation on the supplied probes as usual for the flattest tops with minimal over or undershoot. Below are screen shots of those, along with a couple using a faster timebase to show the leading edge a bit more clearly. I personally think this is quite acceptable, considering the noise floor of the inputs. Also, I would not touch the internal trimmers of the scope, or change anything about the shielding. You could easily throw your scope out of calibration and have no reference to depend on for measurements. The first two images are with DC coupling and the second two are with AC coupling. Hope this is helpful. :) |
| aerra:
Thanks |
| aerra:
good day all! On Hantek website there is last firmware for 1000s dated 01.2015. Is it good? Did anybody tried to update on it? My current versions in attached log |
| Navigation |
| Message Index |
| Next page |
| Previous page |