Products > Test Equipment
Hantek DSO2D10 UART decoding not working
(1/1)
Nilo:
Hi!
I was just trying out UART decoding on my Hantek DSO2D10 and noticed it wont decode, just saying "Please adjust the trigger(No trigger)".
I read the manual and looked up the sections for UART decoding and triggering to set it up right, yet the scope wont decode anything.
I have the CH1 connected to USB/UART converter, baud is 4800, 8 bits, 1 stop bit.
Am I missing something?
My Hanteks firmware is version 3204.
DavidAlfa:
You're probably on FW3204, it's a known issue.
Try FW3202 or 3205, check the FAQ in my signature.
Navigation
Message Index
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod