Products > Test Equipment

Hantek DSO2D10 UART decoding not working

(1/1)

Nilo:
Hi!
I was just trying out UART decoding on my Hantek DSO2D10 and noticed it wont decode, just saying "Please adjust the trigger(No trigger)".
I read the manual and looked up the sections for UART decoding and triggering to set it up right, yet the scope wont decode anything.
I have the CH1 connected to USB/UART converter, baud is 4800, 8 bits, 1 stop bit.
Am I missing something?
My Hanteks firmware is version 3204.

DavidAlfa:
You're probably on FW3204, it's a known issue.
Try FW3202 or 3205, check the FAQ in my signature.

Navigation

[0] Message Index

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod