| Products > Test Equipment |
| Hantek DSO2x1x models: firmware updates and best use practices |
| << < (7/11) > >> |
| morgan_flint:
Hello, Clubfoto. I can't answer your question, but this thread doesn't seem to be very active. There are other two related to this scope with much more activity: https://www.eevblog.com/forum/testgear/hacking-the-dso2x1x/ https://www.eevblog.com/forum/testgear/new-hantek-dso2x1x-models/ Probably, you'll get an answer there, but first check DavidAlfa's super-complete FAQ, as the solution may be already there |
| Aldo22:
--- Quote from: ClubFoto on February 09, 2024, 11:37:58 am ---now I can only use the memory in 4K. --- End quote --- That is normal in decode mode. You don't mean that, do you? --- Quote from: ClubFoto on February 09, 2024, 11:37:58 am ---Does anyone have version 3205 available with which this model came, with that version I could use all the memories. any suggestions? thank you --- End quote --- You can download the firmware from the Hantek website: https://hantek.com/download?key=fjzl&sid=0&pid=17182&word= And yes, read DavidAlfa's FAQ! |
| DavidAlfa:
Only 4K available in decode and HR adquisition mode make aire they aren't enabled. |
| ClubFoto:
--- Quote from: DavidAlfa on March 01, 2024, 02:52:42 pm ---Only 4K available in decode and HR adquisition mode make aire they aren't enabled. --- End quote --- The firmware on your page is older than the one installed, I'm also not sure if I can install older software and if that makes sense. The fundamental problem is that it only works in 4K, regardless of the operations used, it is the same in decoding as in any other operation, of course I have carried out the tests with a single channel. Thank you. |
| Alectronic:
Sadly the link to the backup tool and the Platform tools for the Hantek DSO2D1x scopes is nowhere active! And Hantek only supports upgrading the firmware on a not yet bricked oscilloscope so they are not providing any good service! |O |
| Navigation |
| Message Index |
| Next page |
| Previous page |