Products > Test Equipment
Hantek DSO2x1x models: firmware updates and best use practices
Aldo22:
--- Quote from: ClubFoto on March 04, 2024, 04:37:52 pm ---The firmware on your page is older than the one installed, I'm also not sure if I can install older software and if that makes sense.
--- End quote ---
No FW3208 and 2024.02.02 is newer than your version:
https://www.eevblog.com/forum/testgear/new-hantek-dso2x1x-models/msg5366381/#msg5366381
https://www.eevblog.com/forum/testgear/new-hantek-dso2x1x-models/msg5367956/#msg5367956
Alectronic:
Thanks for the Platform backup & restore tools for the Hantek DSO2D1x oscilloscopes. Links became active some time after logging in on Eevblog. :popcorn:
DavidAlfa:
Links have never been down, unless something temporally broke down at Google.
OLderDan:
Has anybody used the waveform editor to load a custom waveform into the onboard generator? I find the readout to be messed up when trying to adjust amplitude and frequency at the scope, where if I load a sine wave with two peaks, the frequency is halved at the display and the amplitude measurements are not actual, but a percentage of the loaded waveform.
Aldo22:
--- Quote from: OLderDan on April 10, 2024, 02:49:08 pm ---Has anybody used the waveform editor to load a custom waveform into the onboard generator? I find the readout to be messed up when trying to adjust amplitude and frequency at the scope, where if I load a sine wave with two peaks, the frequency is halved at the display and the amplitude measurements are not actual, but a percentage of the loaded waveform.
--- End quote ---
Please be a little more specific with your error reports.
What does “the frequency is halved at the display” mean?
Do you mean the signal generator or the measured frequency?
Of course, in this case the SG shows half of the measured frequency. How is he supposed to know what your arbitrary waveform looks like?
Amplitude: Did you utilize the full vertical range in your arbitrary waveform?
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version