Products > Test Equipment
HANTEK DSO5202P SYSTEM IS NOT SHUT DOWN PROPERLY
(1/1)
alvarosantos:
The equipment was unused for a period of time, when turning it on the message appeared stating that it was not turned off correctly, I have already pressed f2 to restore factory defaults, however without success. I already downloaded the firmware from the official website to try to use the f3 option, but the file is not recognized.
Aldo22:
This video shows a similar problem.
No idea if it is helpful.
https://youtu.be/ofO1WbJ3Z5o
Navigation
[0] Message Index
Go to full version