| Products > Test Equipment |
| Hantek HDG2002B AWG: 5Mhz or 100MHz? Let's see! |
| << < (48/134) > >> |
| rosasharn:
Thanks idpromnut. Could you tell me how to populate the HF BNC connector? |
| idpromnut:
I can post a couple of pictures of my board (I don't think I had the presence of mind t take photos when I had the damn thing open :palm: ). I will look into it tonight. But it should be very very obvious where the BNC connector needs to go (it is the only unpopulated BNC footprint on the board with all the other BNCs on the front of the AWG). I think I linked in the fleabay auction that I bought my BNC from (but beware, the pins on the BNC that I bought were too think to fit the footprint on the board, so I had to file them down). EDIT: Yup, check out my post here regarding the BNC connector auction: https://www.eevblog.com/forum/testgear/hantek-hdg2002b-awg-5mhz-or-100mhz-let's-see!/msg465113/#msg465113 |
| idpromnut:
As promised, here are a few pictures showing the HF counter BNC plus the cut out in the front panel. Note the orientation of the BNC bayonet stubs (they are horizontal versus vertical for the rest). |
| rosasharn:
Many thanks for the photos, everything is clear now. ;D |
| tridentsx:
http://www.mouser.com/ds/2/132/VBM511-1502-194394.pdf I just ordered one of these and the Hantek AWG, hope it will fit the HF with same orientation of the bayonet coupling. |
| Navigation |
| Message Index |
| Next page |
| Previous page |