Products > Test Equipment

Hantek HDG2002B AWG: 5Mhz or 100MHz? Let's see!

<< < (49/134) > >>

idpromnut:
I am not sure but i think the connector you ordered is too low to the pcb and will have trouble fitting through the front panel hole.

rosasharn:
If not sure to add a HF connector on HDG2000B AWG, HDG2000C would be a better choice because it has the HF connector.  :P

rosasharn:
Hello fremen67!
Do you know how to extend the frequency range of HDG2002B frequency counter?

toli:
Hi Guys,

I must admit I ran across this discussion at exactly the right time. I've had my mind set (almost) on the SDG1020 (costs about 300$ shipped), and then I see I can get something with higher BW (after hack), and more importantly with much more memory (which is the main reason I didn't pull the trigger on the SDG1020 yet) for about the same price. However, after reading the entire discussion I can't find an answer to a few questions I have:
1 - I understand there's an issue with the arb "trying to have around 6000 samples [...] and choice of divider isn't always best one". What would that mean? Does this mean you can't have an arb waveform of over 6000 samples? If so what is the point of having 64Mpts of memory? Is there an easy way of uploading the arb data to the generator (as I understand it wont work with SD/USB stick) :)
2 - Are these digital channels any good? Did someone even get them working and can comment on this?
3 - Anyone has a clue if there's going to be a fix to these issues they have in the software? ATM it looks just too buggy, and I didn't see there's any update from Hantek about fixing this. I'm very much worried about things like changing the DC offset causing the amplitude to jump significantly, this is an easy way to damage a circuit under test.

The screen size and the memory depth look way better than SDG1020, but bugs in the software is a PITA too :)

jashugan:
Hello,
I've just oredered the HDG2002B, but I can't use the HDG TTSource program: I can't connect to my PC using the TTSource software, because I can't switch in the Initial menu from the Demo option to Read data or Write data. Can you help me why I can't connect to the software?

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod