Products > Test Equipment
Hantek HDG2002B AWG: 5Mhz or 100MHz? Let's see!
<< < (6/134) > >>
rodlaird:
Sounds like it's a doddle! Thanks mate!

...in fact it seems a bit of a "fail safe" as you could modify things without the reboot and if you screw it up it just clears... (Wish life was like that...  ;) )
idpromnut:
A couple of questions:

- It looks like to the left of the serial header there is a spot for a DB9 + a MAX323-style chip?
- I see the SOIC-8 footprint on the bottom under the HF counter, any ideas what chip part # could go there? I had a look around and came up with this: http://www.micrel.com/index.php/en/products/clock-timing/clock-data-distribution/clock-dividers/article/21-sy10100el32v.html.  Just not sure what type of divider would be needed; this is of course only a /2 divider.
fremen67:

--- Quote from: idpromnut on May 07, 2014, 11:18:45 pm ---- It looks like to the left of the serial header there is a spot for a DB9 + a MAX323-style chip?

--- End quote ---
The 2 spots on the left of the UART header are for the lan option (RJ45 jack + H1102NL Magnetic). See attached picture with populated spots.


--- Quote from: idpromnut on May 07, 2014, 11:18:45 pm ---- I see the SOIC-8 footprint on the bottom under the HF counter, any ideas what chip part # could go there? I had a look around and came up with this: http://www.micrel.com/index.php/en/products/clock-timing/clock-data-distribution/clock-dividers/article/21-sy10100el32v.html.  Just not sure what type of divider would be needed; this is of course only a /2 divider.

--- End quote ---
I also though about a frequency divider. It could be a 1/128 divider as the high frequency input could go up to 2.7Ghz and the low frequency input is still working at 25Mhz. Tinhead suggested a LMX5080 or a MB510 but the pinout to this footprint is strange: 1&8 are connected together (2.5v), 2, 3, 6&7 are grounded and 4&5 are not connected ... :-//
Dago:

--- Quote from: pereczes on May 08, 2014, 11:41:00 am ---want to spend for 80-100mhz signal generator. How much did you spend for it and where did you buy this merveilleux tool?

--- End quote ---

You can get it off eBay for around 250€ shipped.
Control:Eng:
Interessting news!

Quite a bargain when considering the hackability.

I wonder how the Waveforms look like. Do you maybe have a DSO and want to post some measurements here in the forum?

Right now, I'm also considering to buy one of there FG's. Spec's are really awesome.
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod