Products > Test Equipment

Hantek HDG2002B AWG: 5Mhz or 100MHz? Let's see!

<< < (89/134) > >>

tridentsx:

Does the board boot-up without the keypad and screen connected, or is the boot halted ?
Does the boot have any visual indications or audible indications except the main screen ?

When I power on I do get the rails with right voltages, but the screen doesn't turn on, only some of the keys on keypad light up.
I also don't see any output on the serial connections. The voltages looks fine. Will hookup my logic analyzer and see if
there is anything going on at all when I get back home.

Regards /// Carl :-BROKE

fremen67:

--- Quote from: tridentsx on February 02, 2015, 10:12:47 pm ---Does the board boot-up without the keypad and screen connected, or is the boot halted ?

--- End quote ---
It boots on my dev board without screen nor keypad, neither FPGA connected


--- Quote from: tridentsx on February 02, 2015, 10:12:47 pm ---Does the boot have any visual indications or audible indications except the main screen ?

--- End quote ---
I don't think so. You should see the Hantek square barcode logo as soon as the kernel starts


--- Quote from: tridentsx on February 02, 2015, 10:12:47 pm ---I also don't see any output on the serial connections.

--- End quote ---
That's the first thing you should see ... Did you check your soldering close enough?  :-//

Bugdozer:

--- Quote from: fremen67 on February 02, 2015, 07:20:21 pm ---
--- Quote from: Bugdozer on February 02, 2015, 04:08:21 pm ---I received a HDG2022B this past week and decided the to the hack.  Only problem is I'm getting garbage on the Kitty console.  I'm assuming this is a serial connection but what is the baud, data, parity on the Hantek?  Sorry if this was covered, I look around a lot but diden't find anything.  Thanks!

--- End quote ---
115200 Bauds, 8 bits data, 1 stop bit, no parity should work.

--- End quote ---

Success.  The unit I have is running Ver 1.00.3, found the system.inf file residing in /config/root.  Thanks Again!

fremen67:

--- Quote from: Bugdozer on February 03, 2015, 04:11:08 am ---Success.  The unit I have is running Ver 1.00.3, found the system.inf file residing in /config/root.  Thanks Again!

--- End quote ---
Fine! Could you post your complete Hardware/Software versions : sw 1.00.3(xxxxxx.x) and PCB 1xxxx ?
Also is the selftest working on your unit?

Bugdozer:
Ver: 1.00.3 (141255.0)
PCB: 1004.1

Self Test: Ch1 zoom unit 1: Failed
                Ch2 zoom unit 1: Failed

The remaining self tests passed.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod