Products > Test Equipment

Hantek HDG2002B AWG: 5Mhz or 100MHz? Let's see!

<< < (99/134) > >>

rosasharn:

--- Quote from: fremen67 on March 16, 2015, 12:27:57 pm ---
--- Quote from: rosasharn on March 16, 2015, 08:57:00 am ---Is the update calibration tool available now?

--- End quote ---
I should receive my DMM this week so I suppose this could be done at the end of the week ... if it works well  :)

--- End quote ---

Great! Hope have your news soon.  ;D

markone:
Just tried the instrument frequency sweep, with this function the signal it's UTTERLY UNCAL !  :palm:

rosasharn:
 :o

markone:
Just discovered also that AM modulation is now broken (SW 1.0.0.3), see attached image.

It would be a 10Mhz 100% AM modulated signal,  (@10Khz), but as you can see, the deepness is wrong, sure not 100%.

If i remember well, with the previous SW version (1.0.0.2), the AM deepness was right.

I will try to revert to 1.0.0.2 and check.

Guys, stay away from this crap.

markone:
System SW reverted to 1.0.0.2, now AM modulation is right, see attached image (10Mhz carrier, 100% AM modulated @ 10Khz).

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod