Products > Test Equipment
Hantek HDG2002B AWG: 5Mhz or 100MHz? Let's see!
rosasharn:
Could built-in waveforms like StairUp, StairDn, StairUD, PPulse, NPulse, Trapezia, UpRamp, Dn, Ramp, Cardiac, Earthquake and common mathematical waveforms be preloaded onto HDG2000B?
rosasharn:
--- Quote from: rosasharn on April 02, 2015, 07:18:48 am ---Could built-in waveforms like StairUp, StairDn, StairUD, PPulse, NPulse, Trapezia, UpRamp, Dn, Ramp, Cardiac, Earthquake and common mathematical waveforms be preloaded onto HDG2000B?
--- End quote ---
Anyone has clue about it?
rosasharn:
How to establish communication with the device using the USB port on the back of the HDG2000B?
Starcruiser:
@fremen67,
I was looking up colorcoding for the chip inductors and depending on size they will either have no color coding, be a single color or have multiple dots which follow typical resistor coding nomenclature 1st 2nd, multiplier (zero's), see graphic
Starcruiser:
--- Quote from: fremen67 on March 24, 2015, 01:36:53 am ---So I finally received my 34401A :)
Here is the modified version of the HDG calibration tool with:
- Excel x64 support (thank you smgvbest for the feedback)
- 34401A DMM support for DC values
- Rigol DS/MSO2000A support thanks to flatlander
- Excel sheet update improvement
If you don't want to use a device (DMM or DSO), just leave the adresss/alias empty.
The DSO detection type is done using the IDN string so it should be able to detect a DS/MSO1000Z and DS/MSO2000A (hopefully :P).
Depending on the calibration value type, you should be prompted to connect the correct device to the HDG.
I also wanted to add a progress status bar but it's bed time here ...
Hope this will help!
--- End quote ---
Will this work with the DS5202P as a data source? I read that you wrote this for the MSO series but did not see anyting about the DSO mentioned, perhaps I missed it. I would use this with Win7 64bit OS as well.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version