Products > Test Equipment

Hantek - Tekway - DSO hack - get 200MHz bw for free

<< < (643/645) > >>

Merlin11:
Is there a way to hack the Hantek DSO2D10 to go to 200MHz? I've looked here but don't see the how to or any files for a Hantek DSO2D10. Thanks

tgeehobby:
Hi, new member, just joined.

I have the same error 0xfe on my Hantek DSO5102b... I see Tinhead's note re (I think) downloading some stuff from his OneDrive ??  Have no idea how to do this.
Any other help re firmwar failure with the 0xfe error appreciated.

Thanks.

Gregorio:
Hello everyone:
I have purchased a Hantek DSO5202P. When power on it does not show anything on the screen, only some buttons light up. I have connected it via USB to serial to a computer, and I have been able to see that it tries to boot and I share the last lines that it executes:
..........
..........
NAND read: device 0 offset 0x400000, size 0x400000
4194304 bytes read: OK
Boot with zImage

Starting kernel ...

Uncompressing Linux... done, booting the kernel.

It stays on the previous line and does not continue.

I have almost everything to load the fw_backup.bin file, although I am missing the supervivi.bin and/or vivi.bin files

Could someone share them?
I would be very grateful

Greetings to all

morris6:
Hello Gregorio,

A few days ago I stumbled over your post. It's long ago I followed this thread. Sorry.

Are you still needing the requested supervivi and vivi files for the restore of your scope? I found them on the old Windows machine I used at the time, around 2012, for updating the Hantek (Conrad) DSO. (5202 B series).

Attached here an archive with both requested files.

Have fun,

Maurits

Gregorio:
Muchas gracias Morris
Saludos, Gregorio

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod