Products > Test Equipment
have ever you seen multimeter back light change the last counts on the display?
<< < (4/7) > >>
modz786:
After this email they ignore my requests.

So if a fault causes drift but its within their specs then its normal.

So what do I do ? wait for this drift to pass outside specs then they do something? LOL

I wouldn't buy OWON again after the poor customer service.

A firmware upgrade sent via email may have helped but they dont respond.

modz786:
its the same count drift in any DC range. Resistance range not affected

I also tested with the unit on charge and no change.
AVGresponding:
Have you had a look inside it, to see whether it might be possible to mod it to take the BL supply from the pre-reg part of the psu?
modz786:
A consideration for Easter break but I shouldn't be moding a under warranty meter and OWON completely no responsive to further requests for just a simple update for the firmware.

Thanks
py-bb:
Yeah when the battery is low. This can't be helped. There will be a voltage it needs to work, below that it's not fair. The backlight uses a bit of power batteries drop voltage as you load them (the curve varies from battery to battery)


So seriously don't hold it against it

I fucking love my Dialog PL280N which has a button and the backlight stays on until you press it again - I can leave it somewhere and watch it


There should be an icon on the display which indicates low battery.
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod