Products > Test Equipment
have ever you seen multimeter back light change the last counts on the display?
modz786:
After this email they ignore my requests.
So if a fault causes drift but its within their specs then its normal.
So what do I do ? wait for this drift to pass outside specs then they do something? LOL
I wouldn't buy OWON again after the poor customer service.
A firmware upgrade sent via email may have helped but they dont respond.
modz786:
its the same count drift in any DC range. Resistance range not affected
I also tested with the unit on charge and no change.
AVGresponding:
Have you had a look inside it, to see whether it might be possible to mod it to take the BL supply from the pre-reg part of the psu?
modz786:
A consideration for Easter break but I shouldn't be moding a under warranty meter and OWON completely no responsive to further requests for just a simple update for the firmware.
Thanks
py-bb:
Yeah when the battery is low. This can't be helped. There will be a voltage it needs to work, below that it's not fair. The backlight uses a bit of power batteries drop voltage as you load them (the curve varies from battery to battery)
So seriously don't hold it against it
I fucking love my Dialog PL280N which has a button and the backlight stays on until you press it again - I can leave it somewhere and watch it
There should be an icon on the display which indicates low battery.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version