| Products > Test Equipment |
| HDD image request. Teledyne LeCroy HDO6104R |
| << < (3/4) > >> |
| Maximplus:
Thank you all for your help, I have some hopes for success. For some reason it seemed to me that for sure the manufacturer blocked the installation of the operating system, or made the binding of proprietary software to a certain hardware. I'll be glad to be wrong. I made an attempt to download from the official website, but it looks like the account was manually checked by the administrator. Let's see what happens. :-BROKE |
| Maximplus:
I managed to revive the oscilloscope! A clean Windows installation and a MAUI installation were the keys to success. Thanks to the forum members, i able to solve this issue. However, there are still some questions regarding the screen resolution, which needs to be adjusted from 1024x768 to 1280x800. I also need to figure out where the calibration coefficients are stored, either on an old disk or in the FPGA itself. Additionally, there is some uncertainty about the Windows version. Win7 or win10 better? |
| squadchannel:
Is the display driver working properly? Are there any unknown devices in the device manager? If so, what is the hardware ID? I will try to find them. |
| nctnico:
--- Quote from: Maximplus on September 26, 2024, 02:31:26 pm ---I managed to revive the oscilloscope! A clean Windows installation and a MAUI installation were the keys to success. Thanks to the forum members, i able to solve this issue. However, there are still some questions regarding the screen resolution, which needs to be adjusted from 1024x768 to 1280x800. I also need to figure out where the calibration coefficients are stored, either on an old disk or in the FPGA itself. Additionally, there is some uncertainty about the Windows version. Win7 or win10 better? (Attachment Link) --- End quote --- On my Lecroy Wavepro 7k the calibration is stored on the acquisition board. It would surprise me if Lecroy changed this on newer models as it makes recovery of calibration data after a hard drive failure much more difficult. Stick with Windows 7. The drivers may not even work for Windows10. Screen resolution is probably a matter of selection a monitor in Windows which supports 1280x800 and then things should work. Maybe there is a monitor driver file in the Lecroy software which has the right resolution. |
| Maximplus:
It was possible to install the driver of the video embedded in the processor. Everything worked correctly! Yes, there are three unknown devices in the device manager, these are Ethernet, PCI, SM bus controller. The most valuable is the SMBus controller. Hardware ID: PCI/PCI_8086&DEV_1C22& Subsys _1C2210D7&REV_05 PCI/PCI_8086&DEV_1C22& Subsys _1C2210D7 PCI/PCI_8086&DEV_1C22& CC_0C0500 PCI/PCI_8086&DEV_1C22& CC_0C05 |
| Navigation |
| Message Index |
| Next page |
| Previous page |