EEVblog Electronics Community Forum

Products => Test Equipment => Topic started by: luudee on July 30, 2021, 11:22:21 am

Title: Help ! Briked Riden RD6012
Post by: luudee on July 30, 2021, 11:22:21 am

Hi Guys and Gals !

I was doing a firmware update on my RD6012, but it failed in the middle
of the update. Now I just get a black screen on the PSU.

I am using the USB connector on the front panel.

Is there a way to recover and reinstall the firmware?

Thanks!

rudi

Title: Re: Help ! Briked Riden RD6012
Post by: luudee on July 30, 2021, 03:57:35 pm

I found a solution!

Holding down the "ENTER" key while powering it up, will enter the bootloader. That allows the PC
to connect to it again and update the firmware. This time successfully !!!

rudi

Title: Re: Help ! Briked Riden RD6012
Post by: cemelec on July 30, 2021, 04:10:22 pm

I have a 6006 and a 6012, so that's good to know, thanks!