Products > Test Equipment

Help me remove ARMED mode from my UNI-T UPO2102E oscilloscope

<< < (3/5) > >>

Andrew-XZR:

--- Quote from: bdunham7 on September 24, 2023, 11:58:08 pm ---OK, I have to conclude that it is broken.  I'm not familiar with that exact model, hopefully someone else here is an perhaps can help.

--- End quote ---
Thank you very much for helping me... If I believe that it is damaged, the bad thing is that I have practically never been able to use it, even though it is new, I could not claim the warranty because it broke my leg if I did not change it or return it.

Andrew-XZR:

--- Quote from: Bud on September 25, 2023, 12:06:26 am ---Is it same with Channel 2 as the  Source?

--- End quote ---
This is also the case with channel 2, exactly the same behavior for both channels, it does not draw anything and if I touch the trigger configuration it stops responding also when I touch the auto button

Josec:
Why don't remove the pen drive and try again "AUTO".

Andrew-XZR:

--- Quote from: Josec on September 25, 2023, 12:27:17 am ---Why don't remove the pen drive and try again "AUTO".

--- End quote ---
Hello, thank you very much for responding and to all those who write to me... When I press the AUTO button it stops responding until I turn it off and turn it back on... I have left it like this for more than hours and it does not respond

exe:
"Stops responding" mean that the oscilloscope doesn't react on any controls? Like, you press buttons and nothing happens?

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod