Products > Test Equipment

Help restore SDS1102CML+ after unsuccessful flashing

<< < (10/19) > >>

AlexZ:
Hey! Thanks for the help, everything worked, special thanks to tautech, and tv84 for responding to my problem, tautech helped with tools.

StillTrying:
I would have expected all CML+ version screens to look nearly identical, my CML+ looks quite a bit different from AlexZ. There's not much choice in what comes up for the on graticule auto measurements, just voltage, time, or both, which covers more than half area of the screen. :)

Cicciousb:
1. Remove the back cover of the SDS1102CML+ oscilloscope,
2, Remove the metal back of the cage
3. Connect RX,TX serial cables on the unpopulated J11 connector. Solder TX to the second pad and RX to the third pad.
4. Connect to serial: Baudrate 115200
5. Boot the oscilloscope, now you will see the boot log. If not, swap the RX,TX cables to your serial adaptor

hi to all, i have try it but not detected, i dont see any log and siglent stuck on logo. any solution?

tautech:

--- Quote from: Cicciousb on June 01, 2021, 02:55:34 pm ---1. Remove the back cover of the SDS1102CML+ oscilloscope,
2, Remove the metal back of the cage
3. Connect RX,TX serial cables on the unpopulated J11 connector. Solder TX to the second pad and RX to the third pad.
4. Connect to serial: Baudrate 115200
5. Boot the oscilloscope, now you will see the boot log. If not, swap the RX,TX cables to your serial adaptor

hi to all, i have try it but not detected, i dont see any log and siglent stuck on logo. any solution?

--- End quote ---
Welcome to the forum.

PM sent.

Cicciousb:
Thanks, is a pleasure

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod