Products > Test Equipment
Help restore SDS1102CML+ after unsuccessful flashing
Rapanui:
Dear Tautec
I saw on the forum that you helped a lot of people in the same situation as me. I hope you can help me too.
I have an oscilloscope SDS1102CML+ that remains stuck on SIGLENT
It has already happened to me twice!
- The first time: with Maths, it worked
- The second time: Maths did not work, but by booting on a USB key, with the files "datafs.img", "ro_uImage"and "rootfs.img" at the root, it restarted.
This time, neither MATHS nor the boot work :(
Can you help me?
Thank you in advance
tautech:
--- Quote from: Rapanui on November 27, 2024, 05:01:31 pm ---Dear Tautec
I saw on the forum that you helped a lot of people in the same situation as me. I hope you can help me too.
I have an oscilloscope SDS1102CML+ that remains stuck on SIGLENT
It has already happened to me twice!
- The first time: with Maths, it worked
- The second time: Maths did not work, but by booting on a USB key, with the files "datafs.img", "ro_uImage"and "rootfs.img" at the root, it restarted.
This time, neither MATHS nor the boot work :(
Can you help me?
Thank you in advance
--- End quote ---
Welcome to the forum.
Your USB stick is the problem.
Reformat it to FAT32 and 4k clusters.
Also it should be 8 GB max.
Further notes.....some USB sticks do not work for recovery.
There are a few tricks, Full/slow format and someone sent me this:
None of my USB <- 8GB worked first time.
Double checked FAT32 / 4k - but still no go.
Thinking this has to be some MBR / UEFI issue.. I'm using W11 machines only...
However - used Rufus to format one of my sticks as MBR - BIOS - MS-DOS.
Deleted the DOS files from stick afterwards - and copied back the 3 files from your Mega link ... and VOILA :-)
Navigation
[0] Message Index
[*] Previous page
Go to full version