Products > Test Equipment
Help with Symmetricom DTI Signal Generator
(1/1)
sinuspl:
Hello fellows!

Bought an Symmetricom DTI Signal Generator via eBay, has X72 Rubidium Standard inside and serial (RS-232) interface on the front side. Can't set any good parameters in terminal to view and write text. Have tried all speeds, 8 bits, 7 bits, stop bits, etc. Nothing works. Seems to use binary format? Has someone seen and/or configured this unit before?

Please help, want to correct the frequency, is slightly off by 6mHz to GPSDO.

best regards

Gregor
sinuspl:
More info: this is a DOCSIS timinig generator, but has 10MHz ref in and out. It seems, that the rubidium oscillator is not connected to the ref in. There is a CPU inside, connected to all other parts, also to the X72 via serial.

I think I could input 1PPS from the GPSDO and feed it directly into X72. Also could re-wire the front serial connector directly to the X72 module.

best regards

Gregor
Navigation
Message Index
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod