Products > Test Equipment
HOW TO CALIBRATE SIGLENT SDG1032X
uargo:
Hello, I bought a Siglent SDG1032X signal generator and a Siglent SDS1104X-E oscilloscope in 2019, but playing with telnet I deleted the calibration file and the serial number of the SDG1032X, now that I have just bought a Siglent SDM3055 5-digit bench multimeter and a half this week, I want to take the opportunity to calibrate the SDG1032X.
I have written an email to Batronix where I bought it to explain how to calibrate it and/or to provide me with the calibration scripts. They replied that I should consult Siglent directly. I consulted Siglent a week ago and they have not responded.
Can someone here explain to me how to calibrate the SDG1032X and give me the calibration scripts, thanks in advance.
And by the way, you know how to calibrate the SDS1104X-E and if you explain it to me, it would be perfect.
tautech:
--- Quote from: uargo on October 14, 2023, 05:57:53 pm ---Hello, I bought a Siglent SDG1032X signal generator and a Siglent SDS1104X-E oscilloscope in 2019, but playing with telnet I deleted the calibration file and the serial number of the SDG1032X, now that I have just bought a Siglent SDM3055 5-digit bench multimeter and a half this week, I want to take the opportunity to calibrate the SDG1032X.
I have written an email to Batronix where I bought it to explain how to calibrate it and/or to provide me with the calibration scripts. They replied that I should consult Siglent directly. I consulted Siglent a week ago and they have not responded.
Can someone here explain to me how to calibrate the SDG1032X and give me the calibration scripts, thanks in advance.
--- End quote ---
Maybe our recovery packages can help.
Send PM with your email address.
--- Quote ---And by the way, you know how to calibrate the SDS1104X-E and if you explain it to me, it would be perfect.
--- End quote ---
Not available.
Update to latest FW and OS then run Self Cal after prescribed warm up period.
uargo:
Thank you very much I await your PM
uargo:
Hello Tautech, thank you very much for the recovery kit, I put it on a USB and it ran, it seemed to work, but it stayed the same since it already worked and I already had the latest version of the software.
That is to say, it stayed the same as it was. :(
Recovering the old telnet thread on the SDG1032X, I was able to manually modify the file by Telnet and put my real serial number back into it.
But calibrate it I still don't know how to calibrate it...
My reference is the SDM3055 that I bought a week ago and it comes calibrated.
Well, putting the SDG1032X in:
C1: DC 1mV the SDM3055 measures 2.762mV and the UT-71E measures 2.7mV
C2: DC 1mV the SDM3055 measures 2.834mV and the UT-71E measures 2.8mV
uargo:
If anyone knows how to calibrate it and explains it to me, I would appreciate it.
In the old service manual it refers to a calibration script and gives a link that no longer exists. I think years ago this calibration script was available, today there is no trace of it, and I don't know if the current firmware allows it...
Navigation
[0] Message Index
[#] Next page
Go to full version