| Products > Test Equipment |
| How to calibrate Siglent SPD1000X / SPD3303X / SPD3303X-E series power supplies? |
| << < (15/27) > >> |
| oz2cpu:
here my 35 years old justy kit powersupply power on warm up, 5mV full scale, 1800 sec full scale so clearly much worse, when it come to power up time :-) |
| oz2cpu:
short term stability 0.2mV full scale, 10 sec full scale is the best to see this.. this is my right unit SPD3303X ch1 I use the manual set low and hi, for 0.2mV full scale, this was i can compare the curve, fair |
| oz2cpu:
my old psu : short term stability 0.2mV full scale, 10 sec full scale see this is alot more stable, free from short term noise :-) |
| mawyatt:
Here's the GPP4323, then the SDP3303X-E (augmented to a 3303X) and a very old linear EMCO. All set to ~2V. Note the GPP (1st) and SDP (2nd) have a vertical span of 200uv on the SDM3065X, the EMCO (3rd) span is higher at 700uv and not as stable as the GPP or SDP. Best, Edit: Added SD (RMS) over a 5 min time span, GPP ~53uv, SPD ~31uv and EMCO ~76uv |
| Bad_Driver:
Wow, so much information on the last Sunday before Xmas! I have to prepare the upcoming weekend for my three children (and to setup a new XBOX X so far) and for my very old parents too and 4 days in business as well :phew: And I‘m the chief of the kitchen (and the related food shopping drives) Let‘s see what I can repeat with your settings this week. One remark (you see my findings in the SDM-thread): The SDM3065 settles down in a view minutes compared to my HP 34401a, I’m pretty sure that the warming up curve comes from the SPD3303 but I will double check this. It makes sense to use TestController again for this, more post processing capabilities and easier overlay of different measurments. I need more free time for the bench!!!!!! |O |
| Navigation |
| Message Index |
| Next page |
| Previous page |